Powerfix PTSI 9 A1 User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 115
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
9
PTSI 9 A1
GB
IE
Selection of the Temperature Unit
After switching on, the default temperature unit is shown as
degrees Celsius (°C).
Briefl y press the button °C/°F/SET
to switch to the unit
of degrees Fahrenheit (°F).
Briefl y press the button °C/°F/SET
again to switch back
to the unit of degrees Celsius (°C).
Measuring the temperature
Press the measuring button and point the laser dot on the
spot to be measured.
Whilst the measuring button
is pressed, the temperature is
measured and in the display
“SCAN” is shown.
After releasing the measuring button
the last measured
temperature is indicated on the display
and the laser dot is
switched off .
To obtain the most accurate measurement, please note the
following:
The determined temperature is the average temperature of the
measur
ed area. These incr
eases in the ratio of 8:1, the further
away the appliance is from the object being measured.
D = Distance, S = Surface
The target object must be greater than the measuring surface
of the appliance. The smaller the target object is, the less the
distance between appliance and tar
get object must be.
Select the smallest possible distance to the surface being
measured.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 114 115

Comments to this Manuals

No comments